Black & Decker Coffee Makers & Espresso Machines - Recent Questions, Troubleshooting & Support

It will depend on what kind of faucet it is. You can get adapters for the faucet on your kitchen sink but I find they are not very good for pressure washers. They can leak and spray water all over your sink and kitchen. For a pressure washer it is best to have an outside faucet fitted. This will give you the correct type of faucet to connect to and a good supply of water to the pressure washer.
It is usually not very expensive to get one fitted.

Black & Decker... | Answered on Mar 02, 2020

Black & Decker would be a [possible source.

Black & Decker... | Answered on May 10, 2019

I posted this for Chiefbvf earlier: The thermal cutoff switch part number is 36TMH0110603L320-32F (cuts off between 320 and 332F), which I can't find for sale. There is a slightly different one available, however, which cuts off between 315 and 350F, but I can't find an outlet that sells singles. If you can find someone who sells individual parts with serial no: 36TMH0110539L315-50F let me know.

Black & Decker... | Answered on Jan 24, 2019

For ground coffee, use 1-1/2 (one and one-half) tablespoons of beans per 6 ounces of water.

For whole bean coffee, use two tablespoons of beans per 6 ounces of water.

Coffee strength is a very personal preference, so use these numbers as a guideline for middle-of-the-road coffee, and adjust to make the coffee that you like to drink.

Black & Decker... | Answered on Jan 23, 2019

I had my black& Decker for about 6 months or so and it started shutting off after a minute or two of brewing. I cleaned it by running 5 cups white vinagar through it twice and using a filter in basket. Then running 2 pots of clean water through. I had to keep turning it on but by they end of later last pot of water rinse it stay on all they way through .there was an incredible about of lime built up . try it worked for me.

Black & Decker... | Answered on Jan 14, 2019

there is no fix or repair, just replace it

Black & Decker... | Answered on Nov 12, 2018

If you are using your Bialetti for the first time, carry out a few practice brews and throw the coffee out. The coffee oils seal the aluminium surface and will prevent your coffee from having a metallic taste.
Don't clean your moka pot with soapy water or an abrasive sponge. Remember all those great cuppas you made that imparted their special oils onto the inside of the pot? You don't want to go tarnishing that with the taste of dishwashing liquid. Simply rinsing it with hot water and wiping it with a clean cloth after each use will suffice. Alternatively, leave it out on the drying rack for a bit so that it dries out completely.

Black & Decker... | Answered on Jun 26, 2018

the likely fault is a failed start/run capacitor
with this unit failed the field windings draw excessive current which pops the fuse

Black & Decker... | Answered on Jun 07, 2018

From what you described, it sounds like your carafe isn't fitting properly. The lid of the carafe is supposed to open a valve on the bottom of the filter basket. If this valve is clogged or not opening completely, that will produce your symptoms. Also, the warming element will not keep carafe hot if the carafe isn't sitting properly.

Black & Decker... | Answered on Jun 07, 2018

Check the valve on the bottom of the filter basket to be sure it is opening freely and completely. This valve may have some grounds caught in it. If it is clean but appears to be sticking, try some non-stick cooking spray or vegetable oil.

Black & Decker... | Answered on Jun 07, 2018

I would not have waited this long to get a warranty replacement. If you need the proof of purchase, you will have to ask the person who gifted you. Hopefully, the giver will be understanding and help you out.

Black & Decker... | Answered on Jun 07, 2018

Ask Hotel staff to replace it for you.

Black & Decker... | Answered on Feb 20, 2018

first... maybe possibly the model is imprinted on the bottom. it would help alot otherwise we can't help.

Black & Decker... | Answered on Feb 06, 2018

Time to replace it even though it is working perfectly.

Black & Decker... | Answered on Feb 06, 2018

Hello, Srober48 -

Since your Black & Decker coffee maker is only a few months old, it is most likely still covered by warranty.

I suggest you call the Black & Decker Customer Service / Support telephone number printed in your owner's manual / instructions and find out if you can take the coffee maker to an authorized repair center (for free, warranty-covered repair) or if the company will provide you with a replacement coffee maker.

Note: I suggest you do not try to repair the coffee maker yourself while it is still covered by the warranty.

Best wishes.

Black & Decker... | Answered on Feb 04, 2018

Not finding what you are looking for?
Black & Decker Logo

513 questions posted

Ask a Question

Usually answered in minutes!

Top Black & Decker Coffee Makers & Espresso Machines Experts


Level 2 Expert

177 Answers

Sheldon Dedek

Level 3 Expert

912 Answers

Charles Tidwell

Level 3 Expert

475 Answers

Are you a Black & Decker Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides