Bissell Vacuums - Page 7 - Popular Questions, Answers, Tips & Manuals

You need a new switch if it isn't opening the circuit.

roller brush jammed yp with lint , cords and rubbish clean and replace the belt take it to a vacuum repair shop

clean and or change filters --hose clogged

Check the valve at the bottom of machine is closed. It bay be stuck open which stops it from sucking.

If it sprays at the hand tool but not at the floor check the water jets under the machine by the brush roll to see if they are clogged. If they are not clogged you may have a clogged heater.

Pump or motor bearing. Possibly hair around the brush roll. You will have to have it serviced to fix these problems If you need further help, I’m available over the phone at https://www.6ya.com/expert/william_affa8ba20bcbf6c9

First make sure it's putting out enough water. There can be enough water coming out to get the carpet wet but not enough that it picks up much water. This is most often the problem to most machines brought in for repairs. If it's putting out enough water and can't pick it up there has to be something restricting the suction. It could be a clog or something is allowing air to leak restricting suction. Inspect the areas where the suction comes from the machine, through the dirty water tank all the way down to the floor nozzle.

hi. make sure that the handheld is correctly connected into the main body.

There has to be a leak in the suction somewhere. Inspect the nozzle, tank, etc to see if you can find it.

You are not likely to find this. Bissell is very conservative with their product information and there are parts that they don't let consumers purchase, like the pump, because of "liability issues."

you can just cut it off I did the exact same thing with mine but be careful and make sure the hose goes back on all the way

Had a problem with mine not spraying, took ot apart and the heater for the solution was plugged with scaling, cleaned it up and works the very best now. As far as clean water going directly into the collection tank, sounds like the little hose may have a break or a leak in the vacuum hose.

get in an accredited electrician to rewire the cord

Clean the unit thoroughly.

I can't be specific without knowing your make and model number but on most of them you remove the screws to remove the bottom plate, pull the brushroll out, put the new belt on, put brushroll back in and the bottom plate on.

The most common problem is the jets or the heater gets clogged or it needs a new belt or belts depending on the model.

I would sugguest you go for a screening

Check the lever that closes the valve to switch the suction from floor to tools to make sure it's working properly.

take it back for warranty fix or refund