Bialetti Express - Recent Questions, Troubleshooting & Support - Page 5

Acording with bialetti.com that part is not avaliable for replacement, someone who's familiar fixing electrodomestic stuff might give you a better opinion, if can make the trick for you for a few bucks or you can check if is just spring missing, if anything looks right, it could be a fuse inside but you have to open it to check, if you never fix nothing electric before, get some of your friends can check it for you on your presence, never ever leave your machine with no body, you can see it for the las time if you leave it with some one you dont know very well, like your husband or son.

make sure your water level is not too high. needs to be just under release valve inside

Hi there... have had this problem. sounds like you have minerals deposit problem. Put vinegar in water tank, then start machine to let all vinegar come out , it should clean it well. then do over again with water so next coffee doesn't taste like vinegar .If by the time the vinegar pasted through and water doesn't come out faster , it must be another problem. Hope this helps.

Google "Bialetti parts".

Firstly check for clogged holes from where the water comes out. Clean out with big pin or the end of a paper clip. Second, check if mineral deposits have clogged the uptake of the water. Boil a round with diluted vinegar and rinse with several other rounds. Thirdly, make sure you have inserted the coffee holder component correctly i.e. snugly where it fits.

You will need to remove the brewing unit from the base and tip it upside down to inspect/free up the mechanism. While you have it that far replace the seal (barista seal) at the bottom of the brewing chamber that seals the rod on the ejector mechanism. Also inspect the back of that sweeping arm where it runs in a track at the back of the tamping piston ram. A new tamping piston with seals and tank seal would not go astray, all the parts are relatively cheap NZ$40 easily gets the lot.

Lina's Market on Center St N

Although the gasket looked fine, once replaced the coffee pot functioned correctly.