Beko Washing Machines - Page 8 - Recent Questions, Troubleshooting & Support

Yes, it is a fault code!

It could be carbon brushes from the main motor, or a half-broken pump.

pomp i mean pump fail / control fail

door latch / door switch?

not un common for manufacturers to test every 5th , 3rd , 10 th machine if yours came with a defective/ cut/ or otherwise failed pump to drain hose or tub to pump hose. my 15 years in the business hint noisy in spin points at unseated main tub seal/bearing call for factory service don't void warranty by fiddling with it your self ( maybe an easy fix slipped hose,maybe a 3 hr repair for a qualified journeyman appliance technician. .

Hello! It sounds like the triac, which drives the motor is in short, you can recognize from the heatsink, on Beko usually is riveted, not fixed with screw, but you can drill'em off, its an BTB12 ( or 16 ) Triac, replace, thermal grease under and back. Rarely this problem could be caused by tacho circuit error, but ususally Beko just stops and do nothing when tacho error

This code indicates a fault in the water level sensor.

is it going to a rinse hold.awaiting instuction to finish wash?

first part of cycle normally starts pump.if that fails it wont continue.check for blockage

have you tried any other cycles?does the drum turn at all?belt or brushes in motor may be cause

This is most likely an issue with the motor, causing confusion to the electronics, sometimes you can replace the motor and remedy the issue but I have had a couple of occasions with Beko machines where the motor fault caused damage to the control board

Hi balogun
http://www.manualslib.com/manual/15197/Beko-Wm-5140-S.html#manual

I could not add this with the link button but hope this helps

Is it out of warranty?? It sounds like the washer drum bearing failed. Do you use approved super low suds detergent? You can not use regular detergent it will corrode the drum bearing.

Hi Steven I think this also applies to your machine: Beko WM5121W Washing Machine ao com Review I hope this helps.

beko front loaders use sealed bearings .. would suggest try doing several empty hot washes with a strong liquid detergent and as a tester ..put in a white piece of material check for oil sludge in the lint filter if oil persists have it looked at by a professional