Beko Dishwashers - Page 2 - Recent Questions, Troubleshooting & Support

There is not a traditional float that you can see. It counts incoming water with a wheel on the side of machine.

https://www.youtube.com/watch?v=ENkZFJvNznE

Make sure the garbage disposal is clean and hot water Ran through it before you turn on washer. The hose can get obstructed.

There will be something stuck inside the drain pump, You only have one issue, as it is only 2 months old opening it up to unblock may affect your warranty but it's not a problem covered by warranty so they will charge you to fix it, if you decide to try yourself you need to remove the kick panel and you will be able to see the drain pump, you need to unhook it and remove the blockage from it.

Hi,
Here is a tip that will hjelp you with your problem...
Dishwasher Trouble No Water entering Dishwasher
http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering

heatman101

You can try resetting it by cutting power to it for 5 minutes.

Probably a control board issue if valve dies eventually cut off, most likely from overflow switch.

Unfortunately, sounds like either the softener (there is an internal monitoring float) or the pcb (which monitors the float switch position) is at fault. Quite often these faults are more costly than replacing the machine. If you remember to top the salt up once a week, then the machine should continue to operate, as the salt indicator is only an indicator for you to top up.

The computer switch needs replacing (start control)

Click and download the manual: https://www.manualslib.com/manual/214497/Beko-Dwd5410.html Replace temperature sensor.

Ray, you've added this question to a dishwasher thread. You would get better response on a fridge thread.

normally there is a water censor that is in the back of the machine you will need to remove the back and look for a small pipe 5mm diameter going upwards remove it blow gently into it you should hear a click and one when you release the air, if so then the switch is ok but the small metal or plastic pipe where it came from was blocked unblock the pipe return then pipe back to its position and the problem should be gone only attempt this if you are competent and get a friend to help eric