Beko Dishwashers - Recent Questions, Troubleshooting & Support


The float switch should be in the front left corner.

Beko Dishwashers | Answered on Nov 03, 2020


if doesnt feel same as other buttons bad button replace

Beko Dishwashers | Answered on Nov 01, 2020


1. Cycle timer failure
2. Stuck float valve

Beko Dishwashers | Answered on Oct 29, 2020


I have just had this problem with my Beko dishwasher. Mine was running the pump constantly, I tried the tipping method which did reset a switch, and the machine would start to work properly then go back to just pumping again.
I tipped the machine up(lots of water came out) and took the bottom cover off which has a float and a switch in it. This switch stops the water flowing so not to flood your room when there is a leak within the machine. Now I had a good look around for split pipes etc and found that there was a pipe that had popped off completely, I put the pipe back on with a new clip and now it’s as good as new!

Beko 24 in.... | Answered on Sep 03, 2020


If the dishwasher is undergoing short programmes and low-temperature washes then your dishwasher may not allow for the tablet to fully dissolve leaving some remaining tablet left behind. Another reason why the tablet may not be dissolving is because of the water hardness of the area you live in as the tablet may take longer to dissolve in the water.

Beko Dishwashers | Answered on May 03, 2020


There is not a traditional float that you can see. It counts incoming water with a wheel on the side of machine.

Beko Dishwashers | Answered on Apr 03, 2019


Make sure the garbage disposal is clean and hot water Ran through it before you turn on washer. The hose can get obstructed.

Beko Dishwashers | Answered on Jan 06, 2019


There will be something stuck inside the drain pump, You only have one issue, as it is only 2 months old opening it up to unblock may affect your warranty but it's not a problem covered by warranty so they will charge you to fix it, if you decide to try yourself you need to remove the kick panel and you will be able to see the drain pump, you need to unhook it and remove the blockage from it.

Beko DE2541FW 18... | Answered on Dec 27, 2018


Hi,
Here is a tip that will hjelp you with your problem...
Dishwasher2_bing.gif Trouble No Water entering Dishwasher2_bing.gif
http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering

heatman101

Beko 24 in.... | Answered on Nov 06, 2018


Probably a control board issue if valve dies eventually cut off, most likely from overflow switch.

Beko Dishwashers | Answered on Nov 02, 2018


Unfortunately, sounds like either the softener (there is an internal monitoring float) or the pcb (which monitors the float switch position) is at fault. Quite often these faults are more costly than replacing the machine. If you remember to top the salt up once a week, then the machine should continue to operate, as the salt indicator is only an indicator for you to top up.

Beko Dishwashers | Answered on Sep 14, 2018


The computer switch needs replacing (start control)

Beko Dishwashers | Answered on Jul 03, 2018

Not finding what you are looking for?
Beko Logo

297 questions posted

Ask a Question

Usually answered in minutes!

Top Beko Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Paul Carew

Level 3 Expert

3527 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

34972 Answers

Are you a Beko Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...