Avanti Refrigerators - Recent Questions, Troubleshooting & Support
Usually the vent at the rear of the freezer is blocked with ice. Often caused by a faulty heater or defrost timer. Also check the circulating fan for the fridge.
..
Avanti...
•
Answered
on May 17, 2021
HI David,
Please check there: https://manualsbrain.com/en/brands/avanti/fridges/ for a manual. Hope it's helpful
Avanti...
•
Answered
on May 17, 2021
only one and it is " no wine for you"
Avanti...
•
Answered
on May 13, 2021
https://www.manualslib.com/manual/792736/Avanti-Rm3306w.html?page=10
Avanti...
•
Answered
on Jan 04, 2021
Could be due to control board failure
Avanti...
•
Answered
on Nov 22, 2020
Is the motor fan working may be getting too hot. Or you may be able to unplug it for a few minutes then plug it back in.
Avanti WC492D...
•
Answered
on Jul 04, 2020
It is a power supply smd 12 volt 6 A model S 126SMD3 it is craft by www.hanny.com.cn
Avanti...
•
Answered
on Sep 24, 2019
check the switch at back if it is working, check the motor compresor touch the top of the motor comp, if working, the possible problem is the freon, touch the condenser at the back of the unit if hot the freon is working, if no hot, load a freon, ok
Avanti...
•
Answered
on Jul 24, 2019
Is compressor continuously running? If so, and not cooling at all, most likely it’s a freon leak or blockage. If compressor is coming on and off every couple minutes, then it could be relay and overload that plugs onto compressor.
Avanti...
•
Answered
on May 09, 2019
If it gets hot and will not start, the first think to check is the capacitor. The capacitor creates a favorable phase shift on the incoming power and it pushes the motor to spin it at the start winding. Without the capacitor, you don't get that push you need and it does what we call in the field "single phasing". While the term single phasing is usually only used in 3 phase power, you can technically single phase a compressor with single phase power if the capacitor fails because you are losing your favorable phase shift causing in to not spin and overheat. I hope I didn't lose you on my explanation, but I want to try to explain it in a way that is understandable.
You'll have a rating on the capacitor that has a number followed by MFD of uf. This is your microfarid number. Your allowed +/- 6% of the rate capacitor number before is is deemed bad.
You'll need to find someone with a meter that reads microfarids to be able to test the capacitor.
Avanti...
•
Answered
on Mar 30, 2019
Thermostat problem or air damper problem most likely
Avanti...
•
Answered
on Nov 04, 2018
does the compressor start have a close listen could be going out on thermal overload,possible start relay faulty.
Avanti...
•
Answered
on Oct 20, 2018
Not finding what you are looking for?
