Asko Dryers - Recent Questions, Troubleshooting & Support


instruction manual:
http://media.datatail.com/docs/manual/134917_en.pdf

Asko Dryers | Answered on Apr 19, 2020


Unsure if your model has a front housing to be checked.

http://www.appliancehelponline.com/asko.html

Asko

Dryer Failure Code Condition Check/Repair F1 Condensate drain overfilling Check condensate reservoir pump and drain tube. F2 Maximum drying time exceeded (3hrs) - Check for tripped circuit breaker or blown fuse
- Check ductwork for lint build-up
- Check hi-limit and cycling thermostat
- Check heating element F3 Thermistor fault - Open thermistor, replace
- Bad wiring to thermistor F4 Too much lint in the lint filter, front housing, or in the condenser Clean lint from lint filter and/or condenser F5 Fault in the moisture sensor - Lint covering sensor in front of housing
- Bad sensor
- Bad wiring to sensor

Asko Dryers | Answered on Feb 25, 2020


I don't know but dryers generally are of a fairly crude construction designed to be cheaply assembled by the manufacturer and not so easy to repair.

The ones I have tackled, the belt replacement entailed removing screws until something important fell off and then on and on until the back of the cabinet could be separated from the front far enough to change the belt...

Asko Dryers | Answered on Oct 11, 2019


I had the same problem. Turns out the reset button on the back of the dryer needs to be pushed; when you push the reset button you should hear a click. If you do not hear a click the problem was probably not the reset button. The button shuts down the dryer heating elements if they are getting too hot and also keeps the drum from turning unless the start button is held down.

If you push the reset button and the dryer starts to work again, I strongly recommend that you stop the dryer and investigate why the heater elements overheated. In my case there was lint/hair build up on the heater elements themselves. Extensive dryer disassembly is required to properly clean the heating elements but it is worth the prevention of a house fire. While you're at it, clean the rest of the machine and the duct work.

Hope this helps

Asko T700... | Answered on Aug 23, 2019


What is the belt part number for Asko DryerModel # T702C

Asko Dryers | Answered on Jun 27, 2019


If you have a condensate tank that fills up too much the float inside the pump housing will shut the dryer off also.

Asko T721... | Answered on Feb 01, 2019


Check breaker that’s its not tripped.

Asko Dryers | Answered on Nov 15, 2018


I took the top and back of my unit apart. Then from the back it is still not the eaisiet of tasks.

Asko T712... | Answered on Sep 10, 2018


Look in the centre of the back of the dryer for a black rubber seal and press the seal in until you hear a click (this may not apply to your particular model of ASKO dryer). If you are lucky the circuit breaker has done it's job and saved your dryer, otherwise it has been badly damaged and will need electronic repairs to the control board.

Asko Dryers | Answered on Sep 10, 2018


possible temp sensor fault

Asko T712... | Answered on Jul 15, 2018

Not finding what you are looking for?
Asko Logo

590 questions posted

Ask a Question

Usually answered in minutes!

Top Asko Dryers Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Paul Carew

Level 3 Expert

3527 Answers

Ned Halaweh
Ned Halaweh

Level 2 Expert

240 Answers

Are you an Asko Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...