Aquacal Pool & Spa - Recent Questions, Troubleshooting & Support
Error code PO
overheated check gas pressure if not enough it will distort heat exchange
I HAVE NO DISPLAY PUMP
I looked up the users manual for this unit and it said if the display was not working then "ensure the main breaker (located at the power supply panel) and the disconnect switch (located near the heat pump) are both turned ON."
If power is truly comming into the pump then the problem is likely either a bad power supply, connector problem or the display board. There could also be a fuse blown but that would likely be caused by a bad power supply.
I am not sure HeaWave will help but I recommend you call the HeatWave technicalsupport at 800-786-7751 and they might be able to help you figure this issueout. I hope this helps.
Please vote on this answer. Thank you.
Not finding what you are looking for?