Aiwa Car Audio & Video - Answered Questions & Fixed Issues
While driving and listening to
My daughter had same issue with her Aiwa car radio. removing and replacing the radio power fuse made it happy and it has been so for nearly a year.
Won't take cd
All U can do is cry - no warranty and not cost effective to repair the DOA. Tough break.
Buttons stopped working
sounds like you may have a bad switch. if you have a multimeter you can check to see if a switch is reading less then a few megaohms. if one is reading a few kilo ohms, it is probably bad.
CDC-X304 in permanent DEMO mode
I HAVE SAME PROBLEM. AFTER I REPLACED MY DEAD BATTERY MY AIWA CDC-X304 IS STUCK IN THE DEMO MODE. ONLY CD WORKS BUT ALL BUTTONS ON FACING DO NOT RESPOND. ANY SUGGESTIONS HOW TO RESET.
I have a AIWA X204 CD in my car.I don,t know what
I think that's Demo mode.I got stuck there too.This is what worked for me:
- Power the radio off (hold the power button in top left corner in for several seconds)
-
Remove face plate
-
Hold in reset 10 seconds
-
Press push-menu dial/button 3 or 4 times
-
Insert cd and hit source to switch to tuner before cd starts
Not all of these steps may be necessary.I suspect having the power off before the reset button was the important part.
Hi Folks,
I have an
This is what worked for me:
- Power the radio off (hold the power button in top left corner in for several seconds)
-
Remove face plate
-
Hold in reset 10 seconds
-
Press push-menu dial/button 3 or 4 times
-
Insert cd and hit source to switch to tuner before cd starts
Not all of these steps may be necessary.I suspect having the power off before the reset button was the important part.
Fuse for the ash tray for the crysler 300
Fuse #9 feeds the power outlet and fuse #18 feeds the lighter outlet (this is the one I believe your having trouble with).
They are both located in the fuse box in the trunk, next to the battery. If you open the trunk and lift the floor up you'll see them hiding under there. The numbers should be called out on the cover for the fuse box.
Install instructions pyle pld33mu into chevy impala
I'm
sorry but I believe you have this posted in the wrong product
category? Please re-post the question in the proper category if this
is the case, otherwise you have my apologies. This is the car and
truck problem category
AIWA CDC-X115
Check BOTH of your power connections and your ground too. Make sure you actually have 12v at each connection and don't have a blown fuse etc. If you are lucky then you will solve the problem. Good luck.
10/20/2011 1:58:05 AM •
Aiwa CDC-X115
•
Answered
on Oct 20, 2011
•
218 views
I have a CDC-X504MP. How
To get to the sound settings:
Press and hold the Volume knob down.
Press the "Seek" button until you see "Fad" on the display
It will be between "Bal" and "LPF"
Turn the volume knob to adjust
Not finding what you are looking for?
