AEG Freezers - Page 7 - Recent Questions, Troubleshooting & Support

0 Answers

Is a 5.1 cu.chest freezer use 110 or 220 plug

Freezers | Posted on Oct 01, 2019 | Be the first to answer

0 Answers

My insignia ns-cz35wh9 3.5 cu. ft. Chest freezer turns on but i hear a click sound 10 seconds when you plug it in but turns off after 10 seconds and it doesnt get cold at all. What can i do or what part can i replace to fix it?

Freezers | Posted on Sep 29, 2019 | Be the first to answer

2 Answers

Lemair upright freezer,older type about 16 yrs old.Temp control is numbers 1 to 7 not sure if 1 is the coldest or not ?

7 would be the coldest setting no matter the brand or model

Freezers | Answered on Sep 28, 2019

0 Answers

I have an igloo ice maker model ice103 and need to replace drain plug

Freezers | Posted on Sep 24, 2019 | Be the first to answer

1 Answer

The refrigerator cools but the freezer stops and thaws out every week now. It just stops working. tech checked and said it was fine but to clean it out and get it going again. What is causing this?

Sounds like the anti-frost heater is turning on in the freezer. Depending upon the make it can be a faulty controller board or that the light is staying on inside the freezer (also caused by a faulty controller board). Have you had the board changed?

Freezers | Answered on Sep 23, 2019

0 Answers

Where can I purchase the switches for my Igloo countertop icemaker 102 ST?

Freezers | Posted on Sep 23, 2019 | Be the first to answer

0 Answers

I just bought a second hand Samet freezer 20...Can you tell me the functions in the picture what they mean please?

Freezers | Posted on Sep 15, 2019 | Be the first to answer

0 Answers

What is better to repair the issue of my broken motor relay on my small chest freezer,the delay itself or use a 3in1?

Freezers | Posted on Sep 15, 2019 | Be the first to answer

3 Answers

What amp fuse is used on an igloo ice less cooler

do you have the old fuse? If so, carefully read the engraved markings on it

Freezers | Answered on Aug 25, 2019

1 Answer

What is E2 in the ruey shing 4 door freeZer

a general E2 error involves the temp sensor or control board.It may be different for ruey shing. Try unplugging the unit for a minute and plug back in.

Freezers | Answered on Aug 25, 2019

1 Answer

I have a conia upright freezer CUF 183. The power is on but all the lights are off i don't have a manual, what are the lights for and which should be on?

how do you know the power is on if all the lights are off?
If you are referring to the main supply, then maybe there is a reset button on the unit. If the unit is running, then without a manual I can't tell what the lights are for either.

Freezers | Answered on Aug 25, 2019

0 Answers

My igloo portable electronic ice maker model: ice103 quit producing ice, the ice tray doesn't stay shut. What might be the problem?

Freezers | Posted on Aug 25, 2019 | Be the first to answer

1 Answer

What does the amber light mean on my servis freezer

Amber light indicates the fast freeze option.

Freezers | Answered on Aug 24, 2019

0 Answers

The amber light is on on my servis freezer

Freezers | Posted on Aug 20, 2019 | Be the first to answer

1 Answer

I am looking for the

The model number indicates the cubic footage of the freezer.
Example...model number xyz186xxww.,would be 18 cubic feet.
Post your model number on this thread for an exact conversion.

Freezers | Answered on Aug 16, 2019

0 Answers

Trying to find out what my cavalier cedar chest is worth? And how old it is? Still has paperwork stapled on inside of lid..

Freezers | Posted on Aug 15, 2019 | Be the first to answer

1 Answer

Can 2 chest freezers be plugged into a 100' extension cord and freeze properly?

Use an oversized AWG cord, e.g. #12, #10 AWG to avoid voltage drop in the cord. I guess each unit needs 5 amps for total of 10 amps when both run at once.
With a 14 Gage cord (0.5 ohm @ 200' wire) and with both units starting up at same time, the current (amps) draw is 60 amps (6x running current) and 1800 watts, the 1800 watts consumed by the cord, this power dissipated as heat. The 1800 divided by the 60 ( watts/amps = volts) years a voltage drop of 30 volts, at start up of the two compressor motors if at 5 amps flc (full load current). This scenario with a 14 gage, 100' cord is problem bound so a thicker wire cord is needed to keep voltage drops within 10% of the load's rated voltage. Use a 10 or 12 Gage cord or two separate cords.

Freezers | Answered on Aug 14, 2019

0 Answers