3Com NBX - Recent Questions, Troubleshooting & Support - Page 9

HP, Hewlett Packard bought 3com, so you will probably have to download from another site. I have used http://download.cnet.com/Network-3C905C-TXM-Ethernet-Adaptor-Driver/3000-2112_4-109002.html with that card with success for 32bit Windows 7. Hope that helps, Kerry Hostetter

Hi, I hope this link is waht you need. http://www8.hp.com/us/en/support-search.html?tab=1#!=&qryterm=3com 40 0483 001 ethernet&search_searchtype=s-002 If not please the exact model of your device. Good luck

1 Remove power from the Gateway. 2 Disconnect all your computers and the cable/DSL modem from the Gateway router. 3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL port on the rear of the Gateway to any one of the LAN ports. 4 Re-apply power to the Gateway. The Alert LED will flash as the Gateway starts up, and after approximately 30 seconds will start to flash more slowly (typically 2 seconds on, 2 seconds off). Once the Alert LED has started to flash slowly, remove power from the Gateway. 5 Remove the cable connecting the Cable/DSL port to the LAN port, and reconnect one of your computers to one of the Gateway LAN ports. 6 Re-apply power to the Gateway, and when the start-up sequence has completed, browse to: http://192.168.1.1 and run the configuration wizard. You may need to restart your computer before you attempt this. 7 When the configuration wizard has completed, you may reconnect your network as it was before Here on page 85 of the manual 3Com 3CRWE53172 User Manual Forgotten Password And Reset To Factory...

For 3Com that would mean a 3100 series or 3500 series phones. The 3100 series phones are for NBX and VCX phone systems and the 3500 series phones are for VCX only. Both are also SIP compliant.

http://h20565.www2.hp.com/portal/site/hpsc/public/psi/manualsResults?sp4ts.oid=4235318&ac.admitted=1418160958495.876444892.492883150

The keyword to look for is "HP 1910-48G Switch" 2952 SFP 3CRBSG5293 Firmware

This should have the drivers for your 3Com WebCam..

http://www.howtodrivers.com/model565477.html

Try here: http://clubsoftwares.blogspot.ro/2010/12/enet-webcam-driver.html

Try here: http://clubsoftwares.blogspot.ro/2010/12/enet-webcam-driver.html or here: http://www.3support.com/enet-webcam-drivers-original-driver-cd/

If I remember correctly, there is a tiny hole at the back or on the side. Press a paper clip into it. The switch should do a full reset and then reboot. If its just locked up, I would switch off at the power for 15 mins and try let it do an auto restart itself. Do this before you go doing a full button press reset as you may lose any or all updates the switch has had loaded into it.

Go here GENERAL ROUTERS RESETING

Configure the 3COM to direct all incoming 3389/TCP traffic to 3389/TCP on the "private" IP-address (192.168.xx.yy) of your server. Configure your server to "allow" Remote Desktop connections, and add the ID/password details that will be allowed to login to your server.

Usually the upgrade routine is in the router program. Log into the router and find the option to upgrade to latest firmware.