...zener diode, d982. there are no markings on this diode, so i don't know what voltage this zener is. I have seen the schematic, d982 is a 13v 1/2w zener -GR You answered on your own. (lol)If its ...
Question about VS-50501 50" Rear Projection Television
...others listed tested fine but are possibilities.2.) D913 (Minifuse)(264P722010), 3.) Z901 (283P0390202), SF64 Diode next to C925 in secondary4.) D5A09 (264P244030) Zener diode next to ...
My Mitsubishi Cs-40307 was subjected to a power surge from a damaged transformer on the alley pole. It will not turn on or show it is getting power. I opened and checked the main glass-tube fuse and ...
...Zener Diode),D913,D914,C908,C909 were burned out and were replaced. The front display now lights up, but it is still very dim. I asked the tech if there is anything can be done. He said he couldn't ...
Zener or Diode, transistor, allowing dirty DC or AC ripple, to the Caps.. use a scope and have a look. One must always find the cause of why things fail simply fixing the symptoms simply means it will
...zener diode on a board that looks like the Lamp power supply. it actually produces a flash when it crackles. When the TV shuts down, the red Lamp light is lit on the front panel. I've ordered a new ...
zener diode(all are in the power supply section) and the microcontroller. Best that you check the output voltage of each regulator to determine where the fault came from and narrow the job. If you don
Question about WD-62525 62" Rear Projection HDTV
zener diode(all are in the power supply section) and the microcontroller. Best that you check the output voltage of each regulator to determine where the fault came from and narrow the job. If you don
Question about WS-65809 65" Rear Projection Television
...Zener Diode", are another thing to check, those and ordinary "Signal Diode" should always be suspect. next we have Transistors and IC's. The Transistors MUST ALL be checked to see if they have a ...
Question about WS-65809 65" Rear Projection Television
...any advise please hi margaret, seems like the coins have shorted out some front components like zener diodes, fusible resistors etc, in the face. if you not technically minded it wud be best ...
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions