loose connection at the XLR connector. The question I want to ask is how to dismantle the microphone. Regards, Matthew Chu Technical Ministry Evangelical Community Church Hong Kong I am not sure about
Question about PVM 480 Professional Microphone
...cords several times. Something may be loose in the mic. Try tightening the set screw in the tail of the mic near the XLR connector. I that doesn't work it's got to be some loose internal
...XLR cable will be not soldered or wired right,so that the power [phantom power is not getting to the mic] so ensure you have a proper cable for that job...Sorry i can't be more specific but from ...
Question about Microphones Kiwi Professional Microphone
...loose connection If it is not a dodgy XLR cable and you have tried a different mic pre then it sounds like a component or joint in the mic..Only an expert in that field of audio should mess with ...
Question about Beta 57A Professional Microphone
there is a rattle in the mic body as if there is a tiny screw loose Try removing the XLR connector and removing the cartridge to see if there is anything loose inside the handle.
Question about Perception 220 Professional Microphone
...loose, moving around from side to side. at the bottom of the mic where the xlr connector is you'll find a ring screw with two notches. unscrew this and you con remove the lower housing. The upper ...
...loose of the phantom power. Take a closer look at all the connections and check that the phantom power supply voltage is enabled at the mixer. If it's possible check with a multimeter that you have ...
Question about Blueberry Cardioid Condenser Microphone Microphone
Hi, my Blueberry mic's power xlr male chord loose connection with the female chord
...loose wire or a frayed wire grounding out. This could be any of several things. IF the audio output of the mic is at a normal level then the first thing to check is the mic cable. I have several ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions