Docucolor 12 spills fuser oil I have a Doc12 and it spills fuser oil on copies, what can i do? Pretty much all you can do is rebuild the fuser, either the meterins blade or wick are work out. The most
12 fuser oil leaking I have a Doc 12 and I replaced the fuser oil and now it is leaking everywhere and I don't know why or how to fix it. Please help It needs to have the fuser taken apart and rebuilt
error 10186 docucolor 12 what can i fix it thanks 10-186 is a fuser problem.Check for jammed paper in fuser or low fuser oil.Might have bad fuser lamp or fuser thermal fuse.
...Xerox DC-12 have change lower roll & oil asamble than also there is no shining on all media so please guide me to what to do vijay -INDIA E-MAIL : [email protected] Mobile : 098242 24503 hi check ...
because there is not enought oil on the fuser roll. The problem is the oil pump. change it before make one irreversible damage to the fuser or pressure rolls. Do a full maintenance of the fuser module
Docucolor 12. After about a week I found the oil was low again and we had only made a few hundred copies. When we pulled the unit away from the wall I found where all the oil went (nice floor polish).
12 every day. first look at fuser web once out look at the metal roller in side the web slot make sure there is no build up..the large gray fuser rolls should be covered with oil coatting so make sure
...xerox docu 12 when it jams it says 10-105 at the bottom left of the screen This problem is common when heavyweight paper is fed from the tray long edge first. and then the fuser exit sensor did not ...
oil leak use too much oil open ur fuser oil unit clean it with cloths all pipes and oil blade check for leakage and replce oil blade
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions