Questions & Answers for: Fargo wrong ribbon

Wrong ribbon messages I get a message that says "wrong ribbon" after each card is printed Your printer ribbons sensor maybe broken or you could have a main board problem. Call Realstar Solutions ...

...ribbon" mode n there's nothing wrong with it. is stuck in "replace ribbon" mode n there's nothing wrong with it. are you using a ribbon made for the dtc300? there are some ribbons made for the other ...

i have fargo DTC400.i have replced two ribbon,s but it keep saying wrong ribbon.what sould i do to get rid of this? Either your RFID board is bad or you have another ribbon for dtc300 instead.

...ribbon roll. If I remove the green ring on the roll the printer reqinizes the wrong roll is installed but when the correct roll in installed it runs the inal setup then comes back and say out of ...

...wrong ribbon - had the same ribbon in it since the last printing. My DTC300 printer has the same problem. The ribbon supply roller is driven by a small motor connected via an O-ring belt. The printer ...

...wrong color When printing certain badges the printer only prints in Black and white and does not print the Red colrs, new printer ribbon and cleaned the printer. Cut ribbon and start

...wrong? Hi Camille - that is indeed the error message for "ribbon out". This has a few possible causes: 1. Make sure you have the right ribbon for the printer. The standard color (YMCK) ribbon is ...

...film.) 3. The film you've loaded is either not a genuine HID/Fargo retransfer film, or it is the wrong one for your model printer. The usual retransfer film is Fargo part-number 084053. (To check, ...

...Ribbon: Wrong Material" error message, and further description of: " The print Ribbon is not installed properly or has been damaged.". If you're certain the ribbon & film are loaded properly, and ...