Questions & Answers for: wrong ribbon

Ad

Question about 4250 Thermal Printer

1 Answer

Wrong ribbon messages I get a message that says "wrong ribbon" after each card is printed Your printer ribbons sensor maybe broken or you could have a main board problem. Call Realstar Solutions ...

Ad

Question about Wheelwriter 3 Typewriter

1 Answer

...this. 1) Insert the two little feet on the ribbon into the the cut outs on the front of the ribbon deck and snap it into place. 2) If the ribbon dosen't look the same you have the wrong ribbon. ...

Ad

...ribbon" mode n there's nothing wrong with it. is stuck in "replace ribbon" mode n there's nothing wrong with it. are you using a ribbon made for the dtc300? there are some ribbons made for the other ...

Question about DTC-300 Thermal Card Printer

1 Answer

...the guide properly, or is not coming up all the way. Switch the ribbon selector from blk /red and back a few times. If the ribbon is in wrong rethread it. If it is electronic, the ribbon is in

Question about DTC-300 Thermal Card Printer

1 Answer

...wrong ribbon - had the same ribbon in it since the last printing. My DTC300 printer has the same problem. The ribbon supply roller is driven by a small motor connected via an O-ring belt. The printer ...

Question about DTC-300 Thermal Card Printer

1 Answer

...ribbon wrong? What could be the problem? You probanly installed it wrong. Most T/W's spooled ribbons wind to the outside of the spool, however there were a few that wind to the inside. Withe the ...

Question about DTC-300 Thermal Card Printer

1 Answer

...ribbon installed wrong. About 95% of typewriters with fabric ribbons wind to the outside but a few wind to the inside. Type with the ribbon off and watch the take up ratchet and installthe ribbon so ...

Question about DTC-300 Thermal Card Printer

1 Answer

...wrong type of cartridge. A correctable ribbon should be correctable. Is the ribbon being lifted up high enough to correct? Is there any letters on the correction ribbon and is the ribbon installed ...

Question about Monica 2 Typewriter

1 Answer

...or could I have replaced it wrong? Ribbon is wrong replacement? Try removing the ribbon, advancing it a foot or so by hand. Install it, mark the feed wheel type and see if it is turning. ...

Question about Monica 2 Typewriter

1 Answer

...wrong type of ribbon (POOR QUALITY) OR the ribbon could be set up wrong on the printer or you need to reajust the paper and ribbon guides.Out of interest how old are the ribbons you are using - ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

Ekse

Level 3 Expert

13435 Answers

The Knight
The Knight

Level 3 Expert

76823 Answers

Brad Brown

Level 3 Expert

18852 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...