Questions & Answers for: worms in house

I have a Kitchenaid Professional 6 Stand- up mixer. I'm attempting to replace the Worm follower gear that drives the main planetary drive shaft, but cannot figure out how to remove the original. ...

trying to replace the gear worm on a kitchenaid mixer ksm5ps got some do-it-yourself instructions online accompanied by a couple rough pictures but for what seems to be a slightly different model it ...

How do I remove the piston on a 1957 Chev Belair power steering cylinder? YOU HAVE TO REMOVE UNIT FROM CAR.REMOVE THE CONTROL VALVE ASSEMBLY AND THE ACTUATING LEVER.REMOVE THE PITMAN ARM SHAFT ...

I have a burning smell when i turn the mixer on and the gears dont change fast enough. Get a copy of the Repair Part List for your model from Kitchenaid.com Remove the motor housing, lift the main ...

Why won't my sprinkler turn. The water comes out fine, but it won't rotate. Mine is a plastic model, and I can't figure out how to get inside. Why won't my sprinkler turn. The ...

I need to get into the houseing part to oil are clean it does not follow the hose . It starts to then stops. Here's how to open the motor assembly. 1) Use a 5/16 nut driver (or flat screwdriver) ...

i have a John Deere CS36 chainsaw and have removed the oil pump to replace the oil pump worm gear drive. I dropped a washer when removing it and I need to know if this flat washer ( about 3/4" ...

replace the roller bearing on mantisworm shaft I posted this same procedure in a reply to this post: http://www.fixya.com/support/t2127031-tine_shaft_removal_mantis_2_cycle_tiller Follow the procedure

engine runs tines dont 2 cycle mantis tiller The following was extracted from the Mantis owners manual.. At some point, you may find that the tines won't turn when you press the throttle. This may ...

...dogs don't leave my home Do they go the bathroom in the house? They get worms thru contact with infested soil or schitt. If they go outside for even just a bit then they are capable of getting