...worm gear housing. Remove worm gear housing cover. Clamp the worm gear at the top with a vise grip (I think Kuya Jon is correct in that you could skip this step because the transmission won't move ...
...worm gear and put the engine back on. You will probably have to wiggle the shaft until it seats into the clutch. Tighten the flange bolt when the engine is seated flush with the worm housing (with no ...
worm gear box and see if gear is eaten up. Supposed to be greased regularly but gear can wear out over time or overloaded digging. . Don't know your model but here is manual on one of them. See if
Worm gear has a hard spot, and doesn't turn freely. Tines will run for a short period of time and then stop. You will probably need to replace the worm gear and any other worn parts in the gearbox
Question about 2-Cycle Tiller
are the tiller tines supposed to turn while the tiller is not on no the worm gear is not designed to
worm gear housing and while there seems to be plenty it is pretty black ... not sure what color it was to start. Perhaps it needs to be changed, but there is grease in there. Resealed the gear housing
...worm gear shaft by removing the retaining ring at the bottom of the housing and extracting the worm shaft and other associated parts, Adding heat to the bottom of the housing to expand the hole will ...
...locked up what is the problelm The tines do not turn Is the motor running and increasing power with movement of the throttle lever? If so then something is possibly caught in the worm gear
worm gear housing. Perhaps you've been using your Tiller for several years. Or perhaps you've removed the engine for use with the Mantis hedge trimmer attachment, then replaced it. In either case, the
Usually answered in minutes!
410 Questions
52 Questions
5 Questions