...worm gear. Make one or two cuts and oil hole in bar plugs up with saw dust. Changed oil pump assembly because of same problem, thought maybe didn't have enough pressure but still doing same thing. ...
Question about "Chain Saw - 16" Bar, 3 Hp
...worm gear is on the plunger.the gear that is on the crank shaft,if i remember is a nylon gear.some times they look prefectly fine but they slip on the crank shaft and do not trun the worm gear fast ...
...worm gear, c. a pick-up?, d. a filter. How do I get the clutch/bearing assembly off to clean/ replace these parts? Should I try cleaning the filter, should I replace the worm gear? TIA, Lance You are ...
too much slack in steering Replace the joint bushings. There is also an adjustment in the worm gear on the steering box. Thanks, Gary @ Fix Ya.
I have a husqvarna 142 e. I am trying to replace the worm gear and can not get it off. How do I remove the worm gear? I have already removed the clutch. There is a proper tool pt no. 530031136
Question about "Chain Saw - 16" Bar, 3 Hp
...slip on the crank shaft and do not trun the worm gear fast enough to oil. The gear is supposed to slip on the crankshaft, it drives off the back of the clutch so it only oils when the chain is ...
Question about "Chain Saw - 16" Bar, 3 Hp
...worm gear from my backup saw which is an older 372 xp and upon taking out the old one noticed that it was fit with a metal inner piece and that the one I bought at the shop had The saw appears to run ...
youtube how do i repair the oiler? first inspect the worm drive gear that makes the oiler work. this is located behind the clutch and drum. also inspect the bar oiler holes for blockage.
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
model 350 how do i get the oiler working again model 350 depends on why it is not oiling. check bar oiler holes for blockage, pick up filter in tank may be plugged, worm gear may be damaged.
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
How does one take the metal worm gear off the crankshaft for a Husqvarna 142e Chainsaw? Nothing What you need is the Husqvarna 530031136 oil pump gear puller.
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions