Questions & Answers for: work signal loss amp speakers

...Loss Of Sound After an initial period of no probelms the left speaker channel sound deteriorates and then eventually there is no sound at all. I have had this checked 3 times by the service centre - ...

...work from all speakers when not in PLII mode. Please help I would suspect the lead from your tv or video and swap this.ie where are you feeding tv signal to amp from.more than likely faulty lead or ...

...work well originally. I have had to use approx 20 ft. of low level input cable. For the last 7 ft. I have all the speaker cable, a few power cables and a few misc rca cables all jacketed in the same ...

signal is ok. The only way to rectify this problem is to put the amp on standby, unplug the mains lead from the rear of the amp, wait 30 seconds and then reconnect it. The picture is then restored and

signal is ok. The only way to rectify this problem is to put the amp on standby, unplug the mains lead from the rear of the amp, wait 30 seconds and then reconnect it. The picture is then restored and

...signal. Your receiver will drive the rest of the speakers. This is the cheapest way to have your 901's and hear them, too. Since the 901's are really efficient you don't have to buy a big amp that ...

...work during speaker setup? Yes? Not broken. Redefine the failure mode and start over. No? Is it defined to the receiver? Yes? Are you sure the RCA cable is ok? Try another. Still unresolved? Let's ...

...work the set while cooling with a fan , touch to see if any section like power-amps gets hot. If so observe with a magnifier and solder. Check the external antennae connection to the system, if this ...

...work you might want to prove if its a low-level signal loss or a high level amp failure. One way would be to run an RCA cable pair from the Tape Out to any other device (even a TV with speakers) you ...

...work for days, but it always happens again to the left channel only. I have tried the right speaker in the left side and it does the same, and have tried the left speaker in the right side and it ...