Questions & Answers for: Hotpoint wiring the motor

Question about WD62 Front Load Washer / Dryer

1 Answer

...wiring loom from the motor to the control board is cable-tied too tight against the motor. this causes the wiring insulation to weaken and short against the motor causing the constant earth fault./ ...

Ad

...motor wiring plug and earth wire pull out the motor and undue the brushes using a pozi screw drive and replace.. however once you put the motor back in you will have to undue the top to get the belt ...

Ad

Question about WMA32 Front Load Washer

1 Answer

Hotpoint WMA 32 broken wires on Motor? My Hotpoint washing machine WMA 32 kept tripping the circuit breaker on the fuse box. The motor would start but every time the heater element switched on the ...

Question about Ultima WF860 Front Load Washer

1 Answer

...you should make sure the wiring loom is secured properly to the motor. Check the wires around the motor to see if any have bared or are splayed revealing bare wires. otherwise the motor may be

Question about Ultima WD72 Front Load Washer/Dryer

1 Answer

motor/wiring and connections. The most common reason for this is a bad connection or broken wire or last resort, module. Remove the lower back panel and you will see the motor wires (white plug) there

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

how do you remove the brushes from the motor? hotpoint auarius 1000 - drum not turning - how do you remove the brushed from the motor also whaat do the carbon brushes ook like ? thanks You need to ...

Question about Aquarius WMA42 Front Load Washer

1 Answer

my machine wont spin it washes and empties but no spin? seems like the carbon brushes on the motor. To do this unplug machine, and then remove the panel at the bottom of machine on the rear, this is ...

Question about Aquarius WD640 Front Load Washer/Dryer

2 Answers

...the motor and associated wiring. You may just have a broken wire. Click on the link for more Hotpoint, Creda and Indesit error codes. Or use these links for WMA & WM workshop manuals. Take ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

WHAT IS F-11 Hello there Here is the code and the problem and what needs to be checked F/11 Serial Communication Error Communication between the Central Control Unit (CCU) and the Motor Control Unit ...

Question about Ultima WF860 Front Load Washer

1 Answer

...motor plug, or wiring from the module (main control board) to the motor You will need an insulation tester to test the motor unless you can see any burning etc on the plug or wires.Suggest you take ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machine Experts

vince

Level 3 Expert

2530 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Paul Carew

Level 3 Expert

3807 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...