Questions & Answers for: Volkswagen wire mesh

Question about 1997 Golf

2 Answers

reverse problem '97 is popping out of gear in reverse - not so much straight and level ground, but slopped driveway ... is this major or something that can be adjusted and fixed..... thanks ... Hi, I ...

Ad

Question about 1994 Golf

2 Answers

car is heating up? I checked the plastic spherical object and liquid is at max!. The oil is a little low could this be the cause of the temperature gauge rising above 90? Yes it can be. Might be ...

Ad

Question about 2000 GTI

2 Answers

200 Golf GTi 1.8T I lost the select for reverse gear. All the other gears are fine, how can I hanlde thi problem. Tony its can be both modulator valve or signs of a transmission going bad. Auto or ...

I have a 2001 Vw Beetle. The front bumper grille I have a 2001 Vw Beetle. The front bumper grille ( the plastic mesh) is broken in several places. Does a replacement grille mean just the PLASTIC ...

Question about 2001 Beetle

1 Answer

noisey starting vw polo had start motor changed but stiil making the same grinding noise?? possibly the ring gear(teeth on the flywheel that the starter meshes to when cranking)remove starter ...

...weld a crack in the flex pipe of the exhaust? the part where the wire mesh is. no u are unable to repair a broken flex you must have it replaced, should not cost you more that $100 at an exhaust

Question about 2001 Golf

2 Answers

...wire in between the switch and the starter. Hope this helps. Turn on the headlights and try and start the car, if the headlights dim dramatically there is a possible fault with the battery or the ...

Question about 2001 Golf

1 Answer

...wire mesh embedded in the rubber hydraulic hose. Corrosion expands the embedded metal mesh and pushes inward and outward which causes a total restriction of the inner diameter of the hydraulic hose. ...

1999 vw jetta 5-speed. went off the road and got stuck in a ditch. reverse would not work so i had it towed. car drives fine in forward gears but now reverse won't work. if clutch is held in certain ...

i have replaced bearing on the pinion and crown on nissan 3.2. its has a bad noise. how do i adjust pinion and crown? Adjustment to crown wheel and pinion has to be done after bearing replacement on ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...