Questions & Answers for: Viper wire cut

...diode isolated. When the GEM module goes to "sleep" it will set of your alarm . Cut the factory wires where you hooked up the door triggers determine which side goes to the door and which side ...

...690XV which I am going to install using a INT-SL Data interface module. I am just not sure which wire from my cars data port goes to the Data interface module. Thank you, Rico The number 2 pin on ...

cut wire and attach a purple alarm wire to the other end of the cut starter wire. This in turn gives the Viper control over the starter wire. If you can bypass this connection then your vehicle should

...problem if they installed it. Most likely unplugged a wiring harness by accident (or even cut into wrong wire or cut wrong wire) under the dash. Tell them you want you money back unless they fix

...cut factory wiring at speaker and ran new wire to deck. now i wont start,power windows,locks,mirror dont work You cut the speaker wires and your car won't start??? Sounds like you cut more than the ...

...car alarm Check your siren to see if you have a black and, a black and white wire. To increase the volume (delete soft chirp) cut the black wire, cut the black with white wire to delete

...start with the key but, starts with the remote starter; you have an issue with the ignition switch or, the starter wire is cut (like for a starter kill) and the connection is not good on the key

...cut and dry as far as installing the actuators. My question is, What are the remaining 2 wires(1 brown/1white) for? I'm kind of assuming they are for the horns and lights. If so, do they go to the ...

What would cause my car alarm to go off for no reason and my horn to just come for no reason also. and my cig lighters and power plugs chargers not to work. I had to pull fuse to stop them. check your