Vaccum doesn't have power. When pluged in the change bag,change brush sensor lights up and the power won't come on. I had one of these come in for service, a new mainboard was the solution. They're ...
Question about SR12 Sensor Bagged Upright Vacuum
...windsor Sensor brush indicator light will come on when: Something stuck in the brushroller Brushroller is worn and needs replacement height is wrong (indicates a problem with height adjustment) a bad ...
my windsor vacuum brush light keeps coming on You may try a new brush. With these models the light will continuously run to signal it needs the brush replaced.
...light will indicate a brush roll replacement and the bag light indicates a need to empty the bag or look for a clog somewhere in the air flow area of the hose or wand. These machines are designed to ...
Question about SR12 Sensor Bagged Upright Vacuum
...windsor S12 vacuum, but most of them as a same issue with Bad full and Clog light on, even we change new bag and clean all the host, but sill that red light come on and after sometime, vacuum itself ...
windsor sensor xp15 brush light stays on You need to replace your beater bar more than likely, if the light stays on all the time. If it is flashing there is usually something jamming the brush roller
Question about SR12 Sensor Bagged Upright Vacuum
brush warning light I have replaced the brush with a new one. Heigth adjustment appears to be working because the vac head is moving up and down. Brush is turning. Light goes off when handle is in the
Question about Windsor Chassis, Gray Xp15 8.613-821.0
...windsor vacuum go up? It`s stuck in the down position.I have already put in a new brush, bag and servo motor. There are (4) main components that affect the height adjustment on your vacuum. They are: ...
Question about SR12 Sensor Bagged Upright Vacuum
...vacuum bag cleaned out sensor brush, filter, hose and tube You most likely will need to change the Yoke assembly. There is a sensor built in that gets clogged with fine debris over time. This will ...
Question about SR12 Sensor Bagged Upright Vacuum
I have a Windsor SR12. When I Switch the power on, the "Check Brush" and "Bag Full" lights illuminate for about 1/2 second then turn off. The motor does not run. What is going on? could be a swith
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions