...brush sensor lights up and the power won't come on. I had one of these come in for service, a new mainboard was the solution. They're getting power if the lights come on. The board just isn't letting ...
Question about SR12 Sensor Bagged Upright Vacuum
...windsor Sensor brush indicator light will come on when: Something stuck in the brushroller Brushroller is worn and needs replacement height is wrong (indicates a problem with height adjustment) a bad ...
my windsor vacuum brush light keeps coming on You may try a new brush. With these models the light will continuously run to signal it needs the brush replaced.
Question about SR12 Sensor Bagged Upright Vacuum
...sensor SR 12. I also have cleaned rollers and filters and bags. I have reset the handle. When I hit the power the check brush and full bag lights flash once. That is the only power that is getting ...
sensor xp 15 shutting down If you have one of your red lights flashing or on all the time that will indicate where you need to look for your repair. Beater bar light will indicate a brush roll ...
Question about SR12 Sensor Bagged Upright Vacuum
...Windsor Sensor s12 and power shuts off after 5 min. of vacuuming. I'm wondering if it's overheating of if there is some other sensor that causes it to shut off. After we let it cool off for a ...
windsor sensor xp15 brush light stays on You need to replace your beater bar more than likely, if the light stays on all the time. If it is flashing there is usually something jamming the brush roller
Question about SR12 Sensor Bagged Upright Vacuum
brush warning light I have replaced the brush with a new one. Heigth adjustment appears to be working because the vac head is moving up and down. Brush is turning. Light goes off when handle is in the
Question about Windsor Chassis, Gray Xp15 8.613-821.0
... I have included some links to the PC board and Sensor pulley for your convenience. Hopefully this helps. 5465 Red Ring Windsor Sensor 86145060 5740 ER Computer Controller Windsor Sensor SR XP ...
Question about SR12 Sensor Bagged Upright Vacuum
...sensor brush, filter, hose and tube You most likely will need to change the Yoke assembly. There is a sensor built in that gets clogged with fine debris over time. This will take care of the
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions