Questions & Answers for: whirlpool refrigerator cardboard bottom

...bottom.....remove the cardboard cover and see if the fan is running...if its not and it is real hot in the compartment the fan will most likely have to be replaced the freezer compartment works fine ...

...whirlpool refrigerator model ET1FTTXKQ02 and I have ice build up in the bottom of the freezer and water in the bottom of the fridge that eventually spills out onto the floor. If I take the ice out of ...

...whirlpool refrigerator with easy water and ice, not not cooling properly and freezer not keeping ice and food frozen. the insulated cardboard on bottom of refrigerator had stopped the fan. released ...

...refrigerator stopped making ice cubes I am trying to check the water inlet valve, but I am not sure where it is exactly. The water inlet valve is located in back on bottom right side. You have to ...

refrigerator first. make sure the condensor fan is not blocked, or that the cardboard back/bottom piece isn't wrinkled and pushing up into the fan. the fan is located behind the cardboard panel on the

...Refrigerator unplugged from power. Remove the cardboard panel from the bottom, (Watch the water line), and use a vacuum. I also bring the refrigerator towards an open door, and use compressed air to ...

Whirlpool side-by-side fridge model ED5FHEXNB00 started making periodic loud buzzing noise from the bottom rear, behind the cardboard cover. Sounds like a fan issue. The tone/frequency of the buzz ...

...Whirlpool model 6ED25DQFW side by side refrigerator/freezer with ice maker/water dispenser. Water was slowly pooling under the refrigerator under the freezer section. The defrost drain pipe was not ...

...heating. Behind the fridge on the bottom is a cardboard panel. The fan will be behind there. See if the fan is hot or you can spin the blade by hand. If it don't spin very easily replace the

whirlpool refrigerator gi5fsaxvy00 not working not working A non-operational refrigerator is usually caused by a faulty start/overload relay that is attached to the compressor. The unit will have to ...