wheel bearings on a 1997 Honda accord se. We will get the bearings pressed, but need the specs to put everything back together! on a 1999 Honda Accord, the torque for the front axle nut is 181 ft lbs.
...wheel stud and reinstall. P.S. If it is a one piece like quite a few accords are, then you may need a bearing as well due to the breakage rate when they are removed. Hope that helps. also, 80 lbs/ft ...
what is 1998 honda accord front axel nut torque Spindle nut--181 ft lbs. (might seem high but remember that you are not dealing with tapered bearings as in the older models).
...wheel drive Lower ball joint specs: Torque the ball joint-to-control arm nuts/bolts to 85 ft. lbs. (115 Nm). Torque the castellated nut to 108 ft. lbs. (147 Nm). Upper ball joint specs: Tighten the ...
torque requirement for rear wheel bearing Axle nut should be torqued to 139lb-ft.
honda torque specifications what is the torque specs for right side cv driveshaft nut? TIGHT... I normally go to 100-120ft/lbs Then take a Chisel where the Notch is in the Axle and hit the Lip of the ...
Question about 1997 Accord
What are the torque specs for the rear hub assembly axle nut on a 1997 honda accord with drum brakes You can look in your owners manual for torque specs, it list all torque values for the vehicle.
The wheel torque specs for 2013 Honda accord 80 ft lbs
Question about 1997 Accord
...56 plate Rear wheel bearing hub being replaced, what size socket do i need & what is the torque setting for the hub nut http://www.fixya.com/cars/t14552827-size_socket_needed_remove_rear_wheel ...
Question about 1997 Accord
...Wheel Bearing Torque Specifications - DRiV drivcat.com > HubWheelTorqueTableWindow 2009 Ford Fusion ... Front Proc 1 Note ... Front Proc 2 Note ... Do not attempt to tighten the nut with the vehicle ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions