...wheel. 3. Remove the cotter pin and loosen the nut on the tie-rod end stud. Discard the cotter pin. 4. Disconnect the tie-rod end fron the steering spindel with a Pitman arm puller. 5. Loosen the ...
Changing Tire Removed lug nuts and tire won't come off. Four wheel drive 2005 the rim is likely rusted to the hub use a penetrating spray such as pb blaster or aerokroil at the wheel studs. also you ...
Question about 2002 Explorer
wheel knuckle. 10. Remove and discard the upper ball joint nut. WARNING Do not use a hammer to separate the ball joint from the wheel knuckle or damage to the wheel knuckle will result. WARNING Do not
...Wheel Upper shock mounting nuts. Discard the nuts. Nut and the stabilizer bar link. Discard the nut. Bolt, flag nut and the spring and shock absorber as an assembly. Discard the flag nut. Using a ...
...nut and bolt and the wheel knuckle, hub and bearing as an assembly and discard the nut. (Return to) Rear Wheel Bearing REMOVAL AND INSTALLATION 2. Remove the three bolts. CAUTION: Make sure that the ...
...nut for the front wheel bearing. Then you have to take cotter pin out of the main nut on the end of the axle, and take off the nut locking nut, you will need a 32mm socket, (if memory serves me ...
nut somewhere? Do I need to remove the rim or something? If you first jack up the right side with wheel chocks in place and set in park, and take off all of the lugnuts, sometimes the wheel gets stuck
...nut to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Clean the wheel hub and mounting surfaces. Install the tire and wheel assembly. Position the tire and ...
...wheel bearing adjusting nut with the center of the spindle keyway slot. Advance the nut to the next hole if required. To ensure proper wheel retention, install adjusting nut locking key in alignment ...
Question about 1999 Explorer
...wheel studs broke off in the lug nut, how do i fix this? Rotate the hub to a point that the stud will come out. Beat it out with a big hammer. You have to use a nut to pull the other one back in. If ...
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions