Questions & Answers for: Chevrolet Cavalier wheel nut

...nut closes to the wheel then give it a good wack dont hit the thread once its free leave it until you crack the nut on the rack side once you have done this completely remove the old tie rod install ...

torque rating for 2005 cavalier lug nuts need to know the torque rating on my 2005 cavalier lug nuts. It is a 4 cylinder cavalier. Steel wheels or aluminum wheels? Steel-85 ftlbls. Aluminum- 100ftlbs

wheel bearing assembly, but I cant get the axel nut off. The replacement assembly which includes the new nut to go on the axle fit fine in my 1 1/8' deep socket, but the nut on my axle right now, just

...nut it self to remove the wheel cover. Once the wheel cove is off you'll see the real lug nuts holding the wheel in place, note do not over torque the plastic lug nut cover when re installing the ...

...wheel bearing assembly from the spindle ,I already removed caliper,rotor,and the 3 bolts using a size 55 torx wrench that are behind the flange by lining up the holes by rotating the spindle, but for ...

wheel. 2)Remove the cotter pin and large axle nut retainer in the center of the rotor. Remove the two large bolts and nuts attaching the strut to the spindle. Push in on the CV axle where it protrudes

...nut was then removed which took care of any damaged threads due to the grinding. The newly shortened stud is still long enough to adequately hold the wheel on. The only other solution I know of when ...

...could be eiyher one of these or if it is a front wheel the cv joint on the axle could also cause such a noise. Have your wheel hub bearing checked, also make sure your wheel lug nut's are on

is there a locko the front wheel. Was trying to change tire, got the nuts off, but the wheel would not move forward. Try hitting the inside of the tire with a hammer. the bigger the better. What ...

...nut wrench to remove the wheel, unless you have a lock nut (usually one nut is different) and it requires a 'key' to remove that one nut-if they are all the same, however, you just need a lug ...