...nut but the wheel keeps spinning. There must be a trick? On the top of the grinder there should be a button. hold that in while turning the disk (please have the grinder unplugged while you do this). ...
Question about 9015A 5" Electric Angle Grinders
...41/2" can't get nut off to put wheel on Turn otherway. you need to use an air gun to get it off,i had same problem with my wet saw,go to a garrage and thet'll sap it off in 2 seconds with the air ...
Question about Usa Inc 9557PB 4 1/2" Angle Grinder
...nut. The grinding wheel spins to the Right. Using a left threaded nut insures that the nut will stay tight, due to the direction the grinding wheel spins. Lock the shart and spin the blade counter ...
Question about Nip 5"(127mm) Bench Grinder Wheel 743220a
...wheel..how to I get the retaining nut off as I don't have a tool to fit the four holes? Make your own wrench out of a piece of wood stock,with 2 screws or nails spaced out to 2 opposing holes in the ...
wheel. This grinder needs the twin-lug spanner for the front lock nut and it has a locking button to hold the spindle. Spray with WD40 and wait a bit, then get a piece of pipe etc and use as a breaker
Question about MLT100 TABLE SAW FOR 220 VOLTS
...wheel, the blade slowly lowers. on a 3m length of timber the cut at the end can be up to 2mm shallower You almost answered your own question.. As you've already discovered, the blade will slowly move ...
Usually answered in minutes!
103 Questions
45 Questions
43 Questions
32 Questions