Questions & Answers for: Chrysler wheel nut

...nut. Install the tire and wheel assembly. Install the wheel mounting nuts and tighten them to a torque of 100 ft. lbs. (135 Nm). Lower the vehicle. Set the front toe on the vehicle to required ...

...of the strut you need to remove the protective dust cover to gain access to them. Turn the steering wheel to enable easier access to the nuts and bolts at the bottom of the strut. Jack up the front ...

wheel hub preventing the lug nut from pulling the lug stud all the way through the wheel hub, and basically you do not want the lug nut to run out of threads before it can pull the lug stud flush with

wheel hub preventing the lug nut from pulling the lug stud all the way through the wheel hub, and basically you do not want the lug nut to run out of threads before it can pull the lug stud flush with

wheel comes off. Make sure you block at least 2 wheels & have a good jack & on level surface. If you have a jack stand --use as safety support under the axle or frame. No u do not have to pull

...wheel bearing in the front just hub bearings there, back ones should not be too hard just pull off the cover and cotter pin unscrew the nut pull out the outer bearing then put nut back on and yank it ...

...nut down wheel nut until it is firm with water pump pliers----spin the hub/with tire mounted. (the wheel and hub will turn but not freely)----take the pliers and back off the axle nut 1/4 turn----now ...

in the new stud from the rear of the hub.put a larger nut on top of stud ,then your wheel nut to pull the stud into the hub.then remove the wheel nut .then refit the parts taken off.and fit your wheel

...wheel should not wobble if the nut is tight enough. http://www.automobile-catalog.com/make/chrysler/full-size_chrysler_4gen/full-size_4gen_new_yorker_sedan/1964.html ...

My rear wheel/tire are stuck on my car,how do i remove I presume you mean you have removed the nuts and can't get the rim from the hub centre? Sit the vehicle on a jack stand and clout the back of the