Questions & Answers for: weedeater idles rev

...weedeater I always have the choke on but when I take the choke off it stalls out. I have already replaced gas,spark plug looked for leaks, checked the muffler and cleaned the carb. Can anyone help? ...

...weedeater. I have rebuilt the carb, actually two carbs. I have replaced: Fuel tank filter Fuel lines Carb kit Removed plugged screen in carb Replaced primer bulb Cleaned and blown out all openings ...

Weed eater GTI 17 won't run on high speed I have a Weed Eater string trimmer that won't run at high RPM's. When the rev's begin to climb, it just cuts out and stall immediatly. It will start again on ...

...weedeater.Everytime i give it gas,it stalls.Idles fine but stalls as soon as you hit the gas.i put clean gas a new plug in it no good. Depending on how old this unit is, you should be able to adjust ...

weedeater is usable and ready, don't know how to start it ex husband usually does the weedeating and he loaned me our craftsman weedeater. How do I start it? Choke on or off? I hope you have fresh gas

...weedeater starts for about 4-7 sec then shuts down put new hoses on checked gas filter and cap checked out ok. i pump the ball about 10 times ,pull cord &starts for about 4-7 sec then shuts ...

...Weedeater product uses 2 sizes of fuel line. The smaller line must connect to the fuel filter in the tank, and then to the fuel port on the carb that is opposite the diaphragm. The fuel port that is ...

i want to make my weedeater idle down some Before one starts adjusting the carburettor's settings: Bear in mind that small gasoline powered engines need to run at reasonably high idle revs - just ...

WEEDEATER WILL IDLE JUST FINE, BUT WILL NOT REV UP WHEN PULLING ON THE TRIGGER. THE THROTTLE CABLE IS NOT DISCONNECTED AND THE CARB IS CLEAN. ANY SUGGESTIONS? NEW GAS AS WELL. WHAT DO I NEED TO ADJUST

...weedeater Have a sthil 45s rebuilt carb checked fuel lines fuel filter spark plug spark arrestor all clean and working. Still it will only idle will not rev up unless pushing primer bulb any ...