Questions & Answers for: Mitsubishi Eclipse wd no power

...and some soap water to test for an air leak at the side of the head. when you are done spray some wd 40 on it to get the water off so the spark plugs do not arc. ...

sreaching belts which belt is screaching Try a little shot of WD-40 on 1 at a time. Protect your eyes if engine running. If screeching stops, yup, you found the one, but do yourself a favor, if both ...

.../ WD-73837 / WD-82837 Code 17 from the manual: 17 Communication loss, TV Micro - Engine (3.3V-ENG-SDA & SCL) Loss of 12V from PWB-POWER to Engine (Loose PE or PE2 connector). Engine ...

...may fix the issue if it doesnt then you will need to replace the tumbler I agree. Something like WD-40 will probably free it up. If you get it working again, keep it lubricated (about every 6 ...

...in the clutch, saftey feature.and if all ekse fails try sqiirt it ignitioin swich with a little wd-40 stick the kee in gentle and work it in there slowly, hopes this help oh and canyou rate this ...

...a problem. I cannot get the 02 sensors off the stock exhaust! so far ive tried beating them, using wd-40 and a cresent wrench and managed to break my regular wrench! i need these sensors out! any ...

...is stuck in the after market exhaust. I need it out cause the silencer sounds dumb! ive tried using wd-40 a hanger, vise grips and even driving my car around the block 3 times to heat it up and still ...

...cable (moisture gets in the vinyl coated cable, and cable rusts and sticks, you can possibly spray wd-40down the inside of cable, and on the spring and shaft coming off the  plenum/throttle

...at one end of a vacuum system and move forward from there. With the engine running, spray some WD-40 progressively along the lines. You're listening for a change in the idle of the engine. The ...

...and starts to idle higher. what can I do until I can get the new throttle body cable. I have tried wd-40 and it works one time and after that it goes back to doing it again. Those can both be safety ...