...temp is 150 F. The supply from the hot water tank is approx. 140 F. The rinse cycle reaches well above the 180 F min. Is there anyway to adjust the tank temp. on this model or could you suggest a ...
...for the wash tank temp.The rinse temp will only be shown when the display reads (Rinse) and theres a thermistor that screws into the water line near the solenoid valve that measures the
Question about 25 in. LXIH-4 Built-in Dishwasher
...for another cycle. For running continuous cycles, the incoming water will need to be 140 degrees. If you pause 2 minutes between cycles, the temp should remain consistent with a 120 degree
Question about 24 in. LXIH-3 Built-in Dishwasher
...water temp is 120 and there should be enough pressure. Once the machine is ready to go, the water level is about half way up the screen, which seems a little low. Is there some sort of incoming water ...
...water temp settings will require a longer wash and rinse cycle to be programmed into the unit. Of course, you could simply lower the water temp on the water heater that supplies water to this unit, ...
Question about 24 in. LXIH-3 Built-in Dishwasher
...if changeing the cycle times to a shorter setting will get the machine to heat up. I checked the temp on the water supply at 100 degrees. Hi limit is tripped, removed bottom cover and reset hi ...
Question about 42 in. AM14C-154 Free-standing Dishwasher
Can not hold wash temps at 150 degress F.? Once filled the resorvior tank stays filled, but water continues to run out main drain? If it's drain water and filling with water at the same time your ...
Question about Am-12a Commercial Pan Pass Thru Dishwashing Dishwasher Washer
...water temp as incoming water. These new units only use 1.5-3 gallons of water for each fill, so the temp has to be there. Many brands recommend that you run your kitchen sink water until it gets hot, ...
Question about Dishwasher Am-14 Commercial Dish Washer
temp. temps seem fine from other gauge but electronic gauge is not working correctly Your rinse temperature sensor that is a tiny probe in the water piping (top rear of machine) needs replaced. Hobart
Question about C44a Commercial Dishwasher
...water temp. gauge (on piping) is showing 180 but the digital display is only reading 125 deg. then I would remove the water temp sensor from the rinse piping on back upper part of machine (It is a ...
Usually answered in minutes!
200 Questions
119 Questions
51 Questions
65 Questions
34 Questions