Questions & Answers for: Hoover water sensor

water during a 40 degree cycle so steam comes out of the detergant drawer. I have changed the temp sensor at the back of the drum - the problem is still ongoing. if the temp sensor is operating ok but

...see if the inputs of the water level sensor is allowing the program to move forward . If however the motor runs on manual mode/spin, then the fault can be the level detector or the program

...water level sensor which is a pressure sensor in the washing machine can be the most possible problem. So trace the level sensor and check on the switch , you can short the switch to see if the ...

...tube revolve doing washer cycle => water level sensor (pressure sensor) out of order, it is not water in the tube but the signal feed back from the water level sensor to the CPU was full ...

...water level sensor. If the water flow is low then the time taken will be more and so it can cause errors. So remove and clean the inlet valve/filters , check the water level sensor and also check ...

...water temperature sensor (NTC) value is out of range, the "F05" error code will be displayed.Possible Causes / Procedure:1. Unplug washer or disconnect power.2. Check the water temperature sensor. ...

water present a sensor is supposed to turn off the heating coil. This sensor is most likley fail safe, meaning if it is broken it wont turn on the heat because it doesn't know if there is water or

...water temperature sensor (NTC) value is out of range, the "E05" error code will be displayed. Possible Causes / Procedure: 1. Unplug washer or disconnect power. 2. Check the water temperature sensor. ...

...sensor Check pressure switch is not defective Water inlet valve locked open Error 5 NTC fault - temperature sensor detected as either open circuit or shorted Check wiring to temperature sensor Check ...