...pan, pump inlet screen, etc. Replace the pads if they are scaled up and remove any scale from the louvered panels. WITH THE POWER OFF, check the belt for cracking and check to drive motor and blower ...
...pan and then put fresh water in. You'll notice that the water coming out of the purge pump is very foamy. Repeat this five for six times until most of the foam goes away and the smell will be very ...
Question about 67471 Evaporative Cooler Air Conditioner
water and clean up the pan and pump area. Go down to a pool supply store and buy some chlorine tablets and add to the water. In fact, they make these tablets just for the evaporator units. There are 3
Question about 67680 Evaporative Cooler Air Conditioner
...water pan is clean, pump screen and the base of the pump, use something and reach in and spin the pump wheel, allot of the time the pump will hang up, from sitting. But of a longer term solution, ...
Question about 67471 Evaporative Cooler Air Conditioner
go about this?? Remove drain pipe from water pan. You can usually turn it counter clockwise. When drained, clean with fresh water and replace pipe buy placing pipe dope or teflon tape to avoid leaking
Question about 67680 Evaporative Cooler Air Conditioner
...water doesn't spill outside the pan when the unit is turned off. But that enough water is available so that your pump has enough water to feed the pads. If you run the pump dry, you may overheat and ...
...water Pan for my adobe Master Cool Model EC630G Master Cool Cooler????? Where can I get one, and how much for cost? You can find the parts here: ...
...water in pan of one and dripping on my new roof. Wondering why there is water in pan? can you help Yes, there should be a water/condensation pan under it with an overflow drain that takes the water ...
Question about 67471 Evaporative Cooler Air Conditioner
...water can get past the pan. It will take a year or two to find out if this works. I have also considered cutting off the old pan and having a local HVAC shop fabricate a new one using stainless steel ...
...including oil from the factory, on the coil, water will fall off the coil rather than run down to the pan. Try cleaning the coil with mild detergent and lots of water. Pros use a pump
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions