...water level My maytag performa water level is extra large no matter what i put the switch to. Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...water level I have a one year old neptune washer. The water level is too low. The clothes barely get wet and they don't get clean. ck drain hose level ..end should be 30-36 inches from floor also be ...
...Water level controls - The water level control is also know as a pressure switch, this is where you set the water level ( small - medium - large ). The water level control is responsible to shut off ...
...Water level controls - The water level control is also know as a pressure switch, this is where you set the water level ( small - medium - large ). The water level control is responsible to shut off ...
Water level How do I controll the water levels, also are there diffrent water levels or just one level. Water bill was huge just trying to check everything thank you. YOU CAN EITHER CONTROL THE LEVELS
Question about Neptune MAH5500B Front Load Washer
...Water-level switch Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off completely when the electricity has been turned off to it. If this occurs, the ...
...Water-level switch Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off completely when the electricity has been turned off to it. If this occurs, the ...
...Water-level switch Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off completely when the electricity has been turned off to it. If this occurs, the ...
water level does not recognize level....does not stop filling I had the same problem, its the water-fill hose sensor located at the back of the tub. Sometimes it pops off if the tub goes out of ...
Question about Performa PAV2200
...water level switch has a reset, perform this before changing the water level setting prior to your next load, this is usually done by rotating the knob to the reset zone, then back to your desired ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions