Questions & Answers for: water left washing maching spin

...water left in it,but when i shut it and put it through a second spin cyle it's works fine.Sometimes though when i do put it through the second spin when it reaches the countdown of 9 it kinda just ...

...water pump kicks on and the tub oscillates back and forth . The maching does this for 3 to 5 minutes and then attempts to spin again (about 60 RPMs). The machine continues between these cycles ...

left in clothing pockets like paper clips, small plastic items, etc. can get into the pump and lock up the impeller. If you're sure it isn't blocked you can then run a "short cycle", no load and water

...Water goes in but only for 10 seconds then stops and does it aginthen it starts to try and wash. my washing maching needs a clean, it has left dirty marks on my clothes?? I've just had the same ...

...water sounds like it has found its way onto your motor windings. Once it starts burning,carbon is left behind on motor.The decision to replace motor and possibly hole in drum is the question.Need to ...

...left of the filter cap that you can pull out, remove a plug from and drain off any water in the filter before you remove the filter and get your floor wet, so take a look for this before you remove ...

...water still left inside. Following are my complete and hopefully 'coverall' pre-typed guidance notes for checking both the drain motor filter and the drain motor ;-0) REMOVE POWER AND ENSURE ...

...water leaks out. It does not wash. However when you adavance cycle to drain and spin it will work. Can someone advise me how to fix it please There is a rubber tube that goes from the outside of the ...

...left side, right side is OK. I am very puzzled have no service reps here on a small Island must DIY only please help! It seems to just sit in a slowly spin cycle continuously and not count down when ...

...water left in the bottom of the washer (ie, under board the agitator sits on). It looks as if it has fully drained but you can hear it when I move the agitator and can see it when I remove the ...