Questions & Answers for: Chevrolet Astro water intake

Question about 1999 Astro

1 Answer

...water pump and radiator , because not putting proper coolant in radiator. If it is a freeze plug what is process for changing it or them? mmmmmmmm they are really hard to replace but most likelly is ...

Ad

Question about 1998 Astro

3 Answers

intake and heater core was just replaced .coolant runs down from above starter could this be the block plug? sounds to be it may be the block plug or a cracked block. how old is the engine itself? had

Ad

intake assembly Mass Air Flow (MAF) sensor Upper fan shroud Drive belt Fan and clutch assembly Water pump pulley using special tool J 41240 Coolant hoses Water pump Clean gasket mounting surface. Fig.

Question about 2000 Astro

1 Answer

...intake gasket and reattached most of the controls, hoses, etc on the engine so that I could try cranking the engine again. Nothing turned even when I tried jumping the vehicles battery. So, I removed ...

Question about 2000 Astro

1 Answer

...water back to the radiator. Follow the hoses to see which one goes to the radiator and the other will be the heater intake. Another way to tell, with the heat on, the hotter of the 2 will be the ...

Question about 1999 Astro

2 Answers

...intake manifold gaskets. check for leakage behind the water pump. did you change the thermostat? This controls the engine temp. check for rusty radiator cap and replace if worn Could be a clogged ...

...mix with and hold water. you probably have an inch or two of water in your tank, thats where the fuel pump intake is located. you need to get your gasoline from a different store chain. the big ...

leaking water from top of motor driver side need to pressure test system could be a hose or intake leaking

water in it? I would check that first. I believe it would also be blowing some white smoke as well. losing coolant and find no leaking hoses could have intake manifold leak or a head gasket leak check

...the hose from the water pump and hose that goes into intake manifold behind the alternator with a copper 1/2 inch or 5/8 90 degree fitting. maybe $2.00. and two 3/4 hose clamps. maybe another

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...