...Washing Machine Steel Drum is tilted and it makes a lot of noise when it is washing. It caused when we put uneven Load one time You have likely stretched one of the side support springs or knocked it ...
...washing machine, top load The tub seems to be somewhat loose, consequently it tilts forward so that half the water gets into the tub; also you hear strange sounds or noise during spinning. hi without ...
...drum tilted With no water or cloths in drum, it is tilted off to one side. How do I know which shock absorber (suspension spring) is bad. It is tilted of to the back right corner where the ...
...drum doesn't center on its own after is being tilted to a side and seems to tilt during washing. I checked and all the springs are in place and nothing wrong with them. if it is noisy then its loose ...
...washing machine and a piece of bra bone(wire) has gone through the holes in the drum and is stuck and rotating with the drum against the drum outer body how do we get it out- by releasing the seal? ...
...Check the 3 transit bolts on the backside of the machine. Should be removed. Could also be a problem with the balancing spring on the top of the drum, so the drum tilts a bit forward, and cause ...
Question about W6761 Front Load Washer
...washing machine is tilted and won't straighten out. Also makes a very loud banging noise during spin cycle. So loud we can't wash. I guess you washed some curtains and blankets in it that it spun ...
Question about W6761 Front Load Washer
...washing machine fills & drains but does not perform wash cycles or spin cycles drum does not rotate Drum does not rotate Quite probably the motor brushes. Disconnect from mains. Tilt machine ...
Question about W6761 Front Load Washer
...machine not draining? It drains under the drum which has a tendency to clog over time from lint etc. There is a catch screen but that can become clogged also. You can tilt the machine forward to ...
Question about W6761 Front Load Washer
washing machine as the last one tore, after the first wash I’ve noticed this grey rubber dust where the drum meets the seal. What have I done wrong? the main bearing needs replaced drum is tilting due
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions