washer wont go My machine is full. Used to go to next stafe if i banged on the top. Now nothing... help? check the lid hinge screw for looseness if they are tight replace the lid switch
Question about Ultimate Care II LSQ9549L Top Load Washer
...washer ultimate care 2 is in spin cycle it bangs against the sides . if new did you remove shipping strap in back..the unit cant lean more than 2 degrees..make sure clothes are even in tub..try to ...
Question about Ultimate Care II LSQ9564J Top Load Washer
...banging noise upon spinning. If you put your hand on the dasher you can shove it back and forth way too freely and it bangs the outer tub. What could be the matter as the washer is only a little over ...
Question about Ultimate Care II LSQ9564J Top Load Washer
...input, I apologize if this is of no help to you. I've only experienced this with my washer when clothes somehow get bunched up on one side of it. The best I can tell you at the ...
Question about Ultimate Care II GSW9650LW Top Load Washer
Washer agitates off balance and makes a loud banging sound until movement stops at the beginning of rinse cycle, advice? If it makes this noise in the agitate mode and not during the spin cycle, I ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...whirlpool ultimate care 2 stops in mid cycle washer stops mid cycle and will start again when u beat on the lid in a certain spot. what is wrong? Replace the lid switch. check to make sure the screws ...
Question about Ultimate Care II LSQ9549L Top Load Washer
While on high spin the washer makes a loud banging sound. Is something loose or failing? It is OFF BALANCE. Re-distribute the laundry and re-start.
I set the washer up and after it fills with water it stops. I have to bang on the lid to get washer to start. after this its ok, Replace or bypass lid switch. You can also put something heavy on the ...
...washer goes to the spin cycle it starts off ok and then starts banging and banging. louder and louder. The springs seem fine but what other things should i be looking at that could have broken in ...
Question about Ultimate Care II LSQ9564J Top Load Washer
Whirlpool Ultimate Care II Top Load Washer intermittently will not spin. Wife has to bang on the lid a number of times and then it will go. Model # is LSQ8543JQ0 Check the contact on the cover.
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions