...start a load it begins to fill with water - then water fill stops and will not continue unless you slam lid and hit reset. Been doing this consistatnly for week or so now. Only solution is to raise ...
Question about Ultimate Care II LSQ9564J Top Load Washer
...washer. Any suggestions would be appreciated. Thanks, Diane I think it is in the lid switch. If the lid switch is malfunctioning on a maytag top loader it will not start washing. Probably by slamming ...
Question about Ultimate Care II LSQ9564J Top Load Washer
start knob in and out several times. HI, Check and see if the door hinge screws are tight. Sometimes the hinge loosens and the lid switch will not activet properly. It the lid is tight, you might have
Question about Ultimate Care II LSQ9549L Top Load Washer
washer fills up then stops unless i slam the lid then it will start agitating is the lid up during the filling process? the new washers will not agitate unless the lid is down. no need to slam the lid
Question about Ultimate Care II LSQ9564J Top Load Washer
...washer turns on, fills with water, then stops. Agitation won't start unless you slam the lid or sometimes if you "nudge" the setting forward and then pull out and then in. Sounds like door switch may ...
Question about 26882 Top Load Washer
...washer 26 26962 MO 110 26962503 will start the cycle.. Every time I use my washer it will fill with water and then just stop. I sometimes have to slam the lid over and over and then it will start. It ...
...washer will not start unless i slam the top and even then it takes several attempts to get it going. Hi, Sounds like a faulty lid switch. There are a couple of different styles, so I'd suggest ...
Question about Elite Oasis 27052 Top Load Washer
...With the jumper in place, try to re-start the washer. If it works, the Lid Switch is a relatively inexpensive
...With the jumper in place, try to re-start the washer. If it works, the Lid Switch is a relatively inexpensive part and only requires you to access the console and remove the
My Kenmore Elite top loading washer won't start unless i slam the lid. You have to replace the lid switch.
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions