Questions & Answers for: washer squeaks cycle ends

...cycle. It's working perfectly, other than this. Help! Sounds like the brakes have become noisy, just like in an automobile if they glaze over they start to squeak. This really wont hurt the machine ...

...cycle. Hate this machine!!!! Any solution other than replacing? Thanks! SOUNDS LIKE THE MAHINE IS NOT LEVEL LIFT THE WASHER UP AND LET DOWN EASY IF YOU HAVE SELF ADJUSTER IT NOT YOU MUST ADJUST THEM ...

kitchenaid top load washer wont agitate or spin Washer will fill and empty, but will not agitate or spin, it goes through cycles, but when it comes time to agitate or spin it does nothing but make a ...

...washer. The cloths started coming out all tangled up at the end of the cycle. (Other symptoms observed: 1. It seems like the the tub coasts to a stop for a longer period at the end of the cycle than ...

...washer by maytag, and during the wash cycle it is making a grinding noise. Also, at the end of the spin cycle it will make a squeaking noise. What could this be main tub bearing failure. Thanks for ...

...washer during the wash cycle andhold the drun by hand. If the noise stops lool for the loose bolts or replace the springs, they may be weak after that many years. Good luck! Jake, This specific model ...

...washer during the final spin cycle to help remove any soap residue, etc. The part ins't cheap at around $123.00 for this valve, so unless it's really annoying you to no end, I'd wait for the valve to ...

...cycle and somewhat higher than normal transmission failures. Not a bad washer though. In S.Africa, they are an 8.5 kg capacity.Most of these big units are good but overloading these units are the ...

...washer STILL shakes during the spin cycle, I suspect the drum suspension springs/shock-absorbers as being faulty..........................but I would bet that adjustment will cure it! Good luck, John ...

...washer squeaks upon wash cycle and last till end of wash. Gets worse with each cycle. Sounds like rubber rubbing together. Open door, and pull on drum/tub forward and back and see if it moves a lot. ...