Question about LCE4332P 2.1 cu. ft. Top Loading Washer
...washer became SO noisy only during the spin cyle. And then it started leaving dark brown splashes underneath it. Kind of the colour of soy sauce. They dry quickly, and I don't think it's a leak but ...
...run" a load through. Once that "load" is done and I push the coin-filled coin tray in, I get the "unbalanced" light and no action (unless I intervene again with the timer). Any advice? Thanks! Lift ...
Question about LHW0050PQ Front Load Washer
...washer just started to not spin. It was not over loaded, and not unbalanced. It said Sud, but there were no Suds. It has flashed F 02 at me, but is draining fine. If I run it empty it runs great, all ...
...washer empty and the same error code came up. any suggestions?? I had the same problem. I found a water leak on the water valves at the back on the unit. This leak dripped on a wire that lead back to ...
...washing machine always has an unbalanced indicator, even if i run it empty. Check the balance load sensor. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE
Question about 3.2 cu. ft. Plus Top Load Washer
...load is totally unbalanced. I have tried small loads, medium load and even running the machine empty. I confirmed the machine is level and that the nuts on the legs have been tighten to the machine. ...
Question about 3.2 cu. ft. Plus Top Load Washer
run completely empty. a single load can take up to 6 hours to complete.Manufacturer nonresponsive. Solutions? LG issued a recall on certain waveforce washers due to the unbalanced error codes. You may
Question about 1.5 cu. ft. Large Capacity Portable Washer HLP24E
...washer is empty.. Try it with a few clothes placed along the outer walls of the drum. It has a sensor that will try to balance the load before going up to full speed but if there are no clothes or ...
Question about 1.5 cu. ft. Large Capacity Portable Washer HLP24E
...washer does not spin balanced, causing the transmission to fail. My question is: Can this be repaired? Thanks. There were plastic shards in the bottom of tub - we determined the plastic liner was ...
Question about 1.5 cu. ft. Large Capacity Portable Washer HLP24E
...washer is properly leveled. An unbalanced load can trigger the UL (unbalanced load) code. Use a level to check if the machine is sitting evenly on the floor. Load Distribution: Make sure the clothes ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions