...van rpm idles high before the van jerks hard into second gear. I checked the resistance on both the VSS and TPS and all checked good. I get a fault code P1705 for the neutral safty switch; however, ...
speedometer can't read above 80 KmpH. Speedometer not reading above 80 Km/hr; is this a VSS problem? 1998 Mercury Villager. Can I take out the VSS and clean it, if so, where can I locate it? the ...
...working when this happens, what is wrong? speedo gets signal from Vehicle speed sensor on trans (VSS). It may be going bad. Go to autozone for a free computer scan. Does O/D light flash too? go ...
...Faded in and out and then completely stopped. Any ideas? clean the two wire connecto to the VSS, vehcile speed control sensor. It's on the top rear of transmsission. If that doesn't work, it ...
Question about 1995 Villager
...shift quality, etc. I would first check the 2 wire connector on the top back of the trans where the VSS is mounted. Sometimes it gets corroded too. go here too ...
...cable. Raise and safely support the front of the vehicle securely on jackstands. Disconnect the VSS electrical connector. Remove the VSS hold-down bracket bolt and remove the bracket. Remove the ...
The transmission is shifting late. go here http://groups.yahoo.com/group/villagerquest/ sounds like VSS speed sensor not working. dirty connection on top of trans. does speedo work
...working clean the 2 wire connector on the speed sensor on top of trans, driver side, rear of trans. VSS is hard to remove in rust climates so hope it's the connector. go here too ...
where is the speed senor located in my van? and also, the knock senor. do not change the knock sensor, save $600 VSS is on top rear of trans http://groups.yahoo.com/group/villagerquest/
Usually answered in minutes!
478 Questions
379 Questions
326 Questions
276 Questions
247 Questions