ler662 dryer working but not heating up tested element tested ok CHECK FOR 240 VOLTS AT DRYER ELEMENT WITH DRYER RUNNING IN HEAT CYCLE. IF NO VOLTAGE, CHECK WALL OUTLET FOR 240 VOLTS BETWEEN LEFT AND ...
...240 volt between them) white is neutral and green is equipment ground.voltage reading should be 120 volts from red or black to white as well as green, 240 volts from red to black, 0 volts from white ...
...timer. If not, make sure 240 volt breaker is not tripped. Dryer motor and timer only run on 120 volts and heating element uses 240 volts. So, if one side of 240 volt circuit is dead it may be the ...
...HVAC service technician. If you are fimiliar with electrical then just check and see if you have 24 volts to your contactor coil, You shouldn't have. Then check to see if you have 230 volts to the ...
...in need of replacement? FIRST THING IS CHECK YOUR BREAKER TO MAKE SURE YOU ARE GETTING A FULL 220 VOLTS,,,, THEN TAKE THE UNIT OUT OF THE WALL AND CHECK THE VOLTS WHERE THE WIRES HOOK ON THE ...
...breaker. The maximum that this circuit will now load up to is, on #14 wire at 80% = 12 amps at 240 volts. The 120V receptacle must be changed to a 15A - 240V receptacle so that 120 volt devices can ...
Question about RBD305PD Electric Double Oven
...need to get a volt meter and check the incoming power( at the plug ) and make sure you have 240 volts!! it only takes 110 volts to run the top burners, and takes 240 volts to run the
Question about LTE6234D Top Load Stacked Washer/Dryer
...it on a minimum of a 240 volt circuit protected by a 30 amp breaker ,then you should have 120volts from the red wire to the white neutral wire and 120 volts from the black wire to the white ...
Question about LTE5243D Top Load Stacked Washer/Dryer
lte5243dq3 My Brother-in-law rewired my washer/dryer from 220 volts to 120 volts by changing the wiring harness and removing the Red wire completely that was hooked up to the 220 Volt Wiring harness ...
...dadt-ele-2406024 There a few things that can cause no heat in a whirlpool Heater element open 220 volts not there check brackers or use volt meter to see if both sides of have 120 volts whit to red ...
Usually answered in minutes!
1,123 Questions
940 Questions
790 Questions
215 Questions