Questions & Answers for: voltage reduction

...the solenoid are burnt.Pretty common with those gear reduction starters.verify voltage to starter at solenoid when turning key.Will be the small wire on starter.If voltage present put a starter on

...have voltage on the wire to the solenoid while trying to stsrt veh. Usually it is the starter they use a gear reduction on your's i think ans they are common for burning the contacts in the

Voltage shouldn't drop below 10V if all is well. Diesel vehicles usually have a higher torque starter, maybe gear reduction. Depending on age of vehicle, could be worn out. If you're a DIY guy, remove

reduction by adding on a resistor in series to the LED to reduce the voltage/current. It is also possible that the LED wiring in the circuit is not balanced, controlled or regulated. You must then use

...reduction of the screen voltage due to an open resisitor or an open connection can reduce the brightness in the picture . Please check on the CRT base and check the respective grid voltages.-- since ...

...voltage of the circuit.  If a scope is used, use a 10:1 reduction probe, and your voltages can be anywhere from 300 volts to 1200 volts with 650 to 750 being the normally accepted good ...

...reduction in voltage from the engine belt being asked to drive the power steering pump. The engine belt also turns the alternator, which isn't getting as much power from the belt that's now doing 2 ...

No voltage going to the Load reduction Relay blower motor and washer motor are not working. I traced it back to the Load reduction relay not getting voltage. Where do I look next? Fuse

...voltage at rear window the relay is in slot # 2 with the # 18/100 it is called load reduction relay Im not really sure if this will help but check the wires that connect to the window itself and make ...

reduction, flashlight trick proves to be inverters, ran 27vdc chk. & was getting near 20 w/ exception of two inverters. chk'd most everything on pwr. board for amps, voltage & continuity. AM I MISSING