Questions & Answers for: Chrysler Town & Country vents closed

...blower not working, rear works fine. when on highway i can feel some cold air coming through front vents, but very little even on high setting. rear is adjustable from low to high and works well. ...

Check valve missing in fuel tank filler neck. Last year I put STP fuel system cleaner in my 2002 nissan sentra gxe with a fuel tank as instructed on the bottle. Later that day my check engine light ...

where is the motor located for the rear drivers side vent window? It will be located behind the D Pillar panel (the panel where the rod connects to the window that allows the back to open and close)

...which has pneumatic doors that open and close allowing either heat or cold a/c air to flow to the vents of the vehicle. If a door is not opening all the way this can happen, could be a sticking

heater vents close and it sounds like blower motor gets louder when passing gear is used You most likely have a vacuum line leak -- could be in a hose run to the vacuum motors which operate the duct ...

Blower malfunctioning in 2004 Chrysler Town and Country. Sometimes doesn't work at all; sometimes blows a little; sometimes blows on high - all while the switch is on high. no rhyme or reason to ...

what is the pvc valve functionality My car turn off when the weather is cold When you engine is running there is compression gas passing by the rings via the ring gap. This gas goes into the sump and ...

2007 Chrysler T&C overflow tank has pressure When adding fluid to the overflow tank , much of what gets added comes out the vent tube at the top. I have changed the radiator cap since the problem ...

I have a 2007 town and country touring edition .the a/c only works if I put it on defrost first then vent and after about 15 mind I have to put it to defrost again or blows warm air but putting it on ...

power rear vent will not close the mode motor that operates this vent has likely failed this cars are prone to this problem Go back there and close them by turning them I had to do it a few time once ...