Questions & Answers for: Kenmore Elite vent access

...anyone have ANY IDEA of what else could be wrong??? PLEASE HELP!!?? sounds to me like you have a venting problem or the vent is plugged check the vent clean it out. make it as short as you can , ...

access vent behind I have a front loading washer with the dryer stacked above (brand below). They are large and heavy. The two units are in a small laundry 'room'. I need to pull them forward so I can

...and shutting off. Usually is the thermostat not working properly. Make sure the transition vent pipe that conntects the dryer to the vent opening in your floor or wall is the shortest it can ...

e1 pops up after 3 to 4 minutes of drying and turns off it always starts back up and has good heat your help would be greatly appreciated Check your vent hose -- may be clogged

...vent cover, make sure it is the louvered variety. Using any type of screen can clog easily. In addition, you should be using the semi-rigid metal type ducting. It resists kinking, crushing and rodent ...

Access this fuse and pull one wire off. Measure the resistance across the leads of the fuse using a volt/ohm meter. You should measure near zero ohms of resistance (continuity) if the fuse is good. If

Access to the door relay of Kenmore Elite? What is the best way to access the door relay of a front load Kenmore Elite washing machine? If you are attempting to replace or troubleshoot the door latch ...

my he5t dryer wont heat sounds like a thermal fuse,replace that and make sure your venting going out side is clear,thats why this fuse blows

the water wont drain and the is a clicking noise coming out of the water pump motor Something may be stuck in the pump impeller causing it to make a clicking or rattling noise. Disconnect power then ...

...needs to be pulled apart at least once a year to be cleaned out,all it does is move air,if the vent line is blocked or lint builds up in the duct that the lint filter slides into the thermal